• 05132221022
  • 09155122153
  • این آدرس ایمیل توسط spambots حفاظت می شود. برای دیدن شما نیاز به جاوا اسکریپت دارید
  • شنبه تا پنج شنبه از ساعت 9 تا 14 - 16 تا 20
Uln2003 stepper motor driverUln2003 stepper motor driver

uln2003 Stepper motor driver

In Stock: 5
Array

Product Info

ماژول درایور موتور 1 آمپری استپر
ایمیل

One side of the board side has a 5 wire socket where the cable from the stepper motor hooks up and 4 LEDs to indicate which coil is currently powered.

The motor cable only goes in one way, which always helps. On the side you have a motor on / off jumper (keep it on to enable power to the stepper). The two pins below the 4 resistors, is where you provide power to the stepper.

Note that powering the stepper from the 5 V rail of the Arduino is not recommended.

A separate 5-12 V 1 Amp power supply or battery pack should be used, as the motor may drain more current than the microcontroller can handle and could potentially damage it.

 In the middle of the board we have the ULN2003 chip. At the bottom are the 4 control inputs that should be connected to four Arduino digital pins.

HOOKING IT UP TO THE ARDUINO

Connect the ULN2003 driver IN1, IN2, IN3 and IN4 to digital pin 3, 4, 5 and 6 respectively on the Arduino Uno.

Connect the positive lead from a decent 5-12V battery pack to the “+” pin of the ULN2003 driver and the ground to the “-” pin.

Make sure that the “on/off” jumper next to the “-” pin is on.

If you power the Arduino from a different battery pack, connect the grounds together.

بازنگری ها

هنوز نظری برای این محصول وجود ندارد.
با عضویت در خبرنامه ما از تخفیفات ویژه با خبر شوید.

saman-pay

 

© 2018 Pazh Electronics. All Rights Reserved.published by LivingLife